Fiber Optic Connector Cleaning Magic Show - Who Want To Join?

Fiber optic fittings are completely different than every other electronic or electrical fittings. They need to be perfectly clean to be able to work. Many people do not know this fact and may easily overlook its importance. Something else is the fact that fiber optic connections are not as easy to bother shoot just in case and services information outage. Because of this, please learn carefully regarding how to clean a fiber optic connector as below.

Cleaning Method Options

Fiber connector cleaning sometimes could possibly get confusing since a lot of techniques can be found and each single vendor states those are the best. Now let us examine it 1 by 1.

:: Compressed Gas

Compressed air can also be known to as "canned air". It's accustomed to blow dust from fiber connector finish face.

Advantages: Minimal costly and efficient for big dry contaminants. Non-abrasive approach which will not scratch the connector.

Disadvantages: Has little if any impact on contaminants below 3 microns across. And demonstrated to become ineffective when the contamination includes oil, fingerprints, dried solvent residue, etc.

:: Lint-free wipe and solvent

It was the very first developed method for cleaning fiber fittings. The earliest one used some kind of lens paper, cloth and often solvent to wash. The most typical solvent is IPA which has a tendency to leave a residue because it dries gradually and dissolved/suspended solid are left out.

Advantages: Cheap, work nicely if trained correctly. New kinds of solvents which leave very little residue are gaining popularity.

Disadvantages: Hard to rely on. Largely is dependent on technician's skill.

To correctly clean fiber fittings using the wipe and solvent method, stick to the procedure below:

Step One Utilizing a Kim Wipe and cleaning solvent, moisten the wipe by putting on the top from the solvent and push lower 3 occasions, this can saturate the wipe.

Step Two When the wipe is saturated, put on a piece surface having a second (dry) wipe.

Step Three Wipe the connector, finish face lower on moist wipe (this can remove the majority of the large substances). Follow by repeating process around the dry wipe, having a minimum of 3 strokes per connector (more might be necessary)

Step Four Once complete, place connector right into a optical microscope to ensure connector hygiene. If connector doesn't pass visual inspection, repeat process from [Step Two - Step Four]