Autel MaxiFlash J2534 Driver Setup & Network Configuration Guide

by Launch Creader Auto Workshop This instruction show you guide on how to install driver and configure network for Autel MaxiFlash J2534.

Autel MaxiFlash Pro J2534 is reliable, fast performance, and flexible; using the OEM software,it is capable of providing dealer-level programming capabilities for all makes,if it work with the AUTEL MaxiSys MS908 and AUTEL MaxiSYS Pro MS908P, Which can do more car

Procedures:
In order for the Pass-Thru Device to operate correctly with the re-flashing and diagnostic applications on the target PC, you will need to first install the MaxiFlash Pro J2534 device driver onto the PC that will control the device.
To setup the J2534 Pass-Thru device driver, you will need the followings:
 CD with the device driver program
 PC or laptop with USB ports
 J2534 Pass-Thru reprogramming tool
 USB cable NOTE: The following steps may vary depending on the operating system or components that are installed on your computer, but in general this is the standard installation process.
1) Insert the driver installation CD to your PC. The driver installation wizard will load momentarily.
2) Click on ―Next‖ on the welcome page.
3) Select ―Next‖ on the installation location and installation name. It is recommended not to change the default settings; otherwise the computer may have a hard time recognizing the driver.
4) Click ―Install‖ and the driver program will be installed onto your PC. NOTE: During this part of the process a MS-DOS style window will pop up and may remain on your screen for a short while, which is perfectly normal. Do not attempt to close the MS-DOS style window manually as this will prevent the device driver being installed successfully, it will close automatically when the device driver installation is complete.
5) Connect the Pass-Thru device to the PC with the supplied USB cable, a ―Found New Hardware Wizard‖ window will pop up.
6) Select ―Install the software automatically (Recommended)‖, click on ―Next‖, and Windows will search for the driver software automatically.
7) Select the ―MaxiFlash Pro‖ program and click on ―Install‖.
8) When the MaxiFlash Pro device driver program is successfully installed, you should be able to see the ―Maxi Flash Pro‖ entry in the Device Manager under ―Maxi Pass Thru Serial.




NOTE: If the driver installation is not complete or unsuccessful, or the PC still can’t recognize the device, an Error or Question mark will display beside the entry icon. Please try installing the driver program again by clicking the entry, then select start auto searching for the software, or manually locate the specific file that contains the driver program.


Ethernet Connection
Using wired network between the Pass-Thru device and the PC, users can choose either way of connection described as below:
Connecting to a PC Directly
1. Connect the PC to the Pass-Thru device with the supplied Ethernet cable.
2. Open ―My Network Places‖ Properties.
3. In the Properties window, under the LAN or High-Speed Internet heading, right click on the ―Local Area Connection‖ and select ―Properties‖.
4. Now a new window should pop up, titled ―Local Area Connection Properties‖. Here you need to select the Internet Protocol (TCP/IP) option, and then click on the ―Properties button.


http://www.auteleshop.com/wholesale/autel-maxiflash-pro-j2534-device.html

Sponsor Ads

• Ad Space Available - Rent it Now!

Created on Aug 18th 2019 20:13. Viewed 293 times.

Comments