100% positive feedback for KTM BENCH ECU Programmer for BOOT and Bench Read and write 1.99
KTM BENCH ECU Programmer for BOOT and Bench Read and write
KTM BENCH+BOOT Read and Write ECU Programmer Without Open ECU Computer No Car Limited KTM Bench
Note:
Please disconnect internet,do not update yourself . If locked,buyer need pay cost to send back repair. Do not risk this ,thank you .
KTM BENCH Functions:
1. NO LIMITS of the car model and year + NO NEED disassemble ECUs Read and write for Bos** ECUs (Infin***'s chips) incl. flash and eeprom
2. LESS RISK to clone/copy ECUs Able to modify data or do chip tuning to achieve superior performance
3. MUCH CHEAPER, compared with the same functional tools The price is 1/10 of other programming tools in the market
KTM BENCH Support：
Cover for B-M*W N20, N55, N63, etc. to change or read/write ISN codes (done with other tools)
Cover for Ben-tle=y MED17.1.1 to read/write immo data
Cover the latest for Ja-guar MED17.8.32
Cover for V-W MED17.5.5, MED17.5.22, MED17.5.25
...
ALL can be done without ECU disassembling Good equipment of high quality and with the best technology
Professional service and good efficiency
Read and write an ECU in two ways: BOOT and Bench
What is differences between KTMBENCH ,KTMFLASH and KTMOBD?
- KTM Bench Boot is the latest ECU programming tool for ECU read and write via Boot mode or on bench.
- KTMFlash ECU programmer can read the chip data, read & write ECU data. read transmission data etc. at a high speed.
- KTMOBD programmer was born for reading chip data, reading and writing data of ECUs and a few types of gearbox. Read/write data by OBD.Supports most Japanese cars
| ECU programming tool | KTM Bench | KTM OBD | KTM Flash |
| Language | English, Russian | English, Russian | English, Russian |
| Software | **** | **** | **** |
| Run | USB dongle and software | USB Dongle and software | USB Dongle and software |
| Operating system | Window XP;
Windows 7; Windows 10; | Window XP;
Windows 7; Windows 10; | Window XP;
Windows 7; Windows 10; |
| Speed | High | High | High |
| Risk | Less risk | Less risk | Risky |
| Method | via Boot
on Bench (no need to open the cover) | via OBD | Most ECUs need to be disassembled for r/w |
| ECU disassemble | NO | NO | Most yes! |
| ECU read/write | Yes | Yes | Yes |
| Gearbox or transmission read/write | NO | Yes, only a few | Yes |
| Chip read/write | NO | Yes | Yes |
In conclusion:
All programming tools above can be used for ECU read and write, but differs in ECU coverage and Read/Write method.
All programming tools above can be used for ECU read and write, but differs in ECU coverage and Read/Write method.
There is NO LIMITS of the car model and year when using KTM bench to read/write data.
But if you have chips and gearboxes to read and write, you should have a KTM flash. The bad is: disassembling is required. KTM bench doesn’t cover chips and gearboxes and KTM OBD cannot not work good for gerabox Read/Write.
But if you have chips and gearboxes to read and write, you should have a KTM flash. The bad is: disassembling is required. KTM bench doesn’t cover chips and gearboxes and KTM OBD cannot not work good for gerabox Read/Write.
Comments