Repair and maintenance of the counter - quarry crusher in the production line of sand productionby Richard Mrax Crusher Machine
In the production line of sand production line, the counter type quarry crusher is the third step process, after the jaw quarry crusher, and then to the counter quarry crusher, the 20~60mm particles are required by the customer. Counterattack quarry crusher is a kind of impact energy to break the machine.
In order to guarantee the counter - type <a href="http://www.polarrenovationllc.com/">quarry crusher</a>, better in the sand production line in the continuous operation, the continuation of the service life of the quarry crusher, the user should be back - type quarry crusher for regular maintenance and maintenance. After the new machine is put into operation, it is necessary to have a thorough examination of the counter attack. After a week of running to fight back the broken motor, lubrication for a comprehensive inspection. Check the contents of the fixed position of the fastener, belt drive, bearing seal, counter lining board, lining board of the wear and tear of the full, and combined with the maintenance cycle to establish a regular maintenance and replacement system.
Adjustment of the gap between the rotor and the counter liner of the counter quarry crusher:
When the rotor of the impact quarry crusher is in operation, the gap between the rotor and the counter plate can not be adjusted. Such as material into block stranded between the back plate and shell, it is recommended in the re adjustment of the gap between slightly raise counterattack frame, such as pieces of the incoming materials will become loose, counter frame is easy to adjust. If the fight is not enough, can be in a relaxed tie rod (with a piece of wood protection), the rotor and the counter panel of the gap by the machine to complete the adjustment device, first loosen the bolts, and then turn the nut, then the rod will be up in the direction of movement, adjust the screw sleeve.
Created on Dec 31st 1969 18:00. Viewed 0 times.
No comment, be the first to comment.