Installment of Universal Joint on China drive shaft supplier

by Eve W. SEO's little space


Universal joint is a mechanical part that is popular among various applications. Generally, it can also be called u joint, universal coupling, Cardan joint, Hardy-Spicer joint, or Hooke's joint.


It is a joint or coupling in a rigid rod that allows the rod to 'bend' in any direction. It consists of a pair of hinges located close together, oriented at 90¡ã to each other, connected by a cross shaft. Moreover, it can allow positive transmission of rotating power at a much larger angle than is permissible with a flexible coupling. And it can transmit torque and motion.


One of configurations known as a double Cardan joint china drive shaft supplier partially overcomes the problem of jerky rotation. This configuration uses two U-joints joined by an intermediate shaft, with the second U-joint phased in relation to the first U-joint to cancel the changing angular velocity. It is commonly used in shafts that transmit rotary motion.


Universal joints can be widely used in all types of power transmission systems. They have a variety of applications. They can be used in food processing equipments, replacement for expensive gearboxes, and drives, etc. Besides, they are also commonly applied in connecting power take-off china drive shaft suppliers in off-highway tractors that operate drawn machinery such as rotary grass mowers and feed grinders.


They can also be used in vehicles. They are located at both ends of a china drive shaft supplier and serve the purpose of transferring engine power and torque from the transmission to the drive wheels. However, after a certain period, they can wear out because of vibration and many other causes. In order to aviod more serious problems; you should replace the failed u joints on the china drive shaft supplier with new ones.



The first thing you should do is disassemble the driveshaft. Then you have to remove caps and unfasten the four holding clips on the caps. Be sure to aign the U joint tool with the yoke and twist the bolts until the cross and caps are at a distance which will enable the parallel cap's removal. Be careful not to drive the cap being used to apply pressure into the other side of the yoke. Separate the yoke from the U- joint tool and the cap that has been pressed through.


Next, you may have to use a socket for centering the cross while the pressed cap is being pushed back from the other side of the yoke. And reinstall the u joint tool and twist the bolts until the left over cap is pushed to the other side of the yoke.


Thirdly, you just have to install new caps and follow the process which is exactly the opposite of removal. Twist the screw until the cap is pushed enough to go past the holding clip furrow. At last, you have to repeat this process for each cap until all the caps and cross are aligned with the yoke. In addition, you should check to make sure that cars do not make clunking noises when changing gear or vibrate with the speed of the transmission output.

Sponsor Ads

About Eve W. Freshman   SEO's little space

0 connections, 0 recommendations, 24 honor points.
Joined APSense since, August 4th, 2014, From nanjing, China.

Created on Dec 31st 1969 18:00. Viewed 0 times.


No comment, be the first to comment.
Please sign in before you comment.