Articles

How to adjust the remote control for car remote control

by Loisea Ben Juguetes baratos

If you are in the RC toy store to buy a coches radiocontrol, there may be a salesperson to help you debug the various settings of the remote control. However, if the remote control car that you buy on the Internet, you may not so lucky. In any case, often to debug remote control is a remote control car enthusiasts must do things.But for beginners, these things have to go through repeated contact and test to grasp the essence.

Remote control car toys on sale, shapes, and usually they have a big LCD screen, there are a number of buttons. The trouble is that each brand of remote control setup process and project name. In fact, we do not have to worry about. Remote control, no matter how complex, its basic features are similar.Any car remote control before commissioning, be sure to restore the original settings, and then adjust.This is necessary because the manual will tell you the control components and the effect of each key. adjust according to the instructionsis the first step.

When we are able to master the function of each control button, our preliminary learning how to fine-tune the remote control car traveling venue. The required operations are not the same for every type of traveling venue.Especially for the sensitivity of the control lever needs to do the trimming.Balance of centrifugal force caused by the turning of a car traveling in the remote vehicle was an impact.The the traveling venue of friction is determined according to the road conditions.We need to adjust the controller are: the power control lever, Trim control lever, Exponential.

On a flat road surface, we need to moderate the sensitivity of the sensitivity of the controller was adjusted to moderate, power control lever can. TRIM you need to fine-tune to the lowest sensitivity, because the flat road does not require too much control. In rough terrain, the opposite. TRIM requires very high sensitivity in order to adapt to the different slopes of the tire contact. Power down to the lowest sensitivity of the control rod. Debugging is to avoid remote control car stuck in one place and burned the motor.

Finally, double-check every line of Radio Control car receiver.Avoid control failure.If your controller and car model does not exactly match, you should take the way to adapt to the remote control, rather than to do the fine-tuning.Remember, the highest state of fine-tuning to adjust our operations.


About Loisea Ben Junior   Juguetes baratos

2 connections, 0 recommendations, 11 honor points.
Joined APSense since, December 28th, 2012, From madrid, Spain.

Created on Dec 31st 1969 19:00. Viewed 0 times.

Comments

No comment, be the first to comment.
Please sign in before you comment.