Fixing a Warn Safety on a Walther P22 - cheap Youth Nike NFL Jerseys jerseys

by fa yi yifa If the screws are snug and the lever is still falling, we'll have to look elsewhere for the cause of the problem wholesale nfl jerseys. The next step is to remove the safety lever screws and inspect the slide and the underside of the levers for damage or debris.

If everything looks clear, you'll need to keep going cheap nfl jerseys. If you find some obvious dirt or other obstructions, give the area a good cleaning and then reassemble the pistol to see if the problem is fixed.

If the lever is still giving you problems, it's time to do some light filing Nike NFL Jerseys. Remove the safety levers again and examine their underside.

You'll notice that there's a raised portion in the middle of the lever that sits inside a sunken portion in the slide that when turned engages the safety wholesale nike jerseys. You'll also see the detent ball that snaps into the detent hole on the slide to hold the lever in place.

The detent ball is the source of the problem. When it doesn't fit snuggly enough into the detent hole on the slide the safety lever drops. To fix the problem, you need to remove some material from the back of each safety lever so they sit closer to the slide and the detent ball sits deeper in its hole. To accomplish this use a fine file to gently remove a little bit from the backside of each lever. You want to file the raised portion in the middle of the lever and the areas beside it evenly. You don't want to remove more material from the middle than from the sides or more from one side than the other. If you do, the lever will sit unevenly against the slide or it won't fit snuggly against it which can lead to more problems. Don't go crazy! You won't have to remove much material to get the job done and you can always remove more, but you can't out any back.

Sponsor Ads

• Ad Space Available - Rent it Now!

Created on Dec 31st 1969 18:00. Viewed 0 times.

Comments