Brother Printer Phone Number To Have Brother Laser Jet Printers Issues Solution
by Marry Linda Printers ServicesPeople all across the world prefer Brother laser jet printers
because this gives you the advance and clean printing. Ink jet printers
produces wet printing that it do not get dry properly due to which many times
printing get spread and look filthy. But you are not going to have any such
trouble with the Laser jet printing because its printings are fine, smooth,
clean and dry, thus you can have the finest printing. Though laser printer
technology are fine but sometimes it might produce some errors due to which you
may face trouble. However, with this article you will come to know about the
few issues and solution for your printer.
Common
problem and solution with your Brother laser jet printer
·
Toner do
not stick to the page
It happens may be because of defects in the
fuser assembly, thus here you need to change the fuser. It may also occur due
to problem in toner cartridge, thus here you can replace toner cartridge
cleaning out your printer.
·
Paper
get jammed while printing
This problem occurs because of the dust, stain
or plain dirt that enter in to printer or may be because of the paper quality.
Solution: Clean
your printer after particular period of time or you may ask Brother customer
service to resolve this problem. You should always good quality paper because
most of the time too light and heavy paper may cause jamming.
·
Printer
is showing error message as 50.4
This basically occur due to power supply
Solution: Check
that where your printer is plugged in, it’s in your UPS or in the wall because
one should never plugged in printer in the UPS as power flow is required by the
printer. This is needed to keep the fusee assembly warm. If it does not work
then you can also contact Brother printer customer service.
·
Faded
printer pages
There are varied reasons due to which this
problem occurs. There might be that toner is low, print density is low or there
Economode is on.
Solution: Remove and shake the toner cartridge. This will
temporarily resolve your problem but you should install new cartridge or you
should also look for the print density settings.
·
Printer
is showing 79 error
It mainly cause due to network print server. It
may also shows the printer failure on add-on-component such as RAM module or
MIO card.
Solution: To
troubleshoot this problem you open the folder of the printer from the start
menu to be sure that no jobs pending.
After going through all these process if again you are
getting problem then you can call Brother customer service number who will
deeply going to diagnose your problem and going to provide you instant
solution.
Sponsor Ads
Created on Dec 31st 1969 18:00. Viewed 0 times.