Packaging machine Leather Desk Set

Granule Packing Machine does not often appear solenoid pull phenomenon, Leather Desk Set the most likely cause for this failure is the host internal fault, the solenoid coil blown, line interruption and other reasons,the solution is: first check is the host of a problem inside or outside; second view solenoid fuse to see if there are power electro-magnet signs, rule out mechanical jamming, everything is normal in the case of detection of the internal power supply; often encountered in weighing packing machine is the reason for this failure are: the sensor is damaged, voltage for the bridge failure, or interruption of the line connection is wrong, remove the method: detection sensors and signal connections or load host, near the bridge and amplifier circuit for testing or computer output display circuit, and sometimes there will be stability of the system instability caused by the amount of bad bags solve this problem can test whether the fault line, or remove the host, through an internal short applied clear signal to determine fault in the machine or from the switch, and then solve the problem.

Should always take apart and wash the filter impurities (usually 1-2 months cleaning, debris-like objects such as packaging should reduce cleaning time). Wine Accessories Set 2-3 months of continuous work should open the cover of 30 pairs of sliding blocks parts and lubricating touch switch on the heating of the connecting rod on the activities should be considered at the use of lubrication. Vacuum, filter, oil mist triple pieces 24 should always check to ensure that oil mist, oil cup of oil (sewing machine oil), cup filtered water. Vacuum packaging machine should be at a temperature of -10 -50 , relative humidity less than 85%, non-corrosive gases in ambient air, no dust, non-explosive environment. The same as strapping and shrink machine, the vacuum packaging machine for the three-phase 380V power supply. Vacuum pump for the vacuum packaging machine to ensure the normal operation, vacuum pump motor does not allow reverse.

Heating section, silicone strips to keep clean and not stick with foreign matter, so as not to affect the sealing quality.Heater, and heating under the floor sticky paste pieces from the insulation, should be promptly replaced when damaged, to avoid short circuit. User-owned work and inflatable air gas source, vacuum packaging machine working pressure is set to 0.3MPa, more appropriate, no special circumstances do not regulate too much.Vacuum packaging machine in the handling process does not allow inclined position and impact, but can not be tipped over handling,such as Bag making Machine. Vacuum packaging machine is installed must have a reliable grounding device. Non-heated rod into your hands to prevent injury, an emergency power off immediately. The first work after the power ventilation, power shutdown after the first expire.Storage Gift Boxes

Report this Page

Created on Jun 11th 2012 01:35. Viewed 132 times.

Share on APSense

Comments