Installation of I-2014 Multi-diag scanner 2014 Multi-diag Access J2534

by Obd2motor Elena obddiagnosticcenter.com DIY your car diagnostic to

2014-I Multi-Diag Access J2534 Pass-Thru OBD2 Device is obddiagnosticcenter.com newest Multi-diag diagnostic tool. Than old version Multi-Diag, New 2014V Multi-diag Access J2534 can run on win xp and win 7 32bit system.

Multi-Diag diagnostic scanner 2014-I multi-diag access J2534 diagnostic tool

Latest I-2014 Multi-Diag support 23 brands with 5300 new car systems. Have about 20 languages to choice. Do you know how to use 2014-I Multi-diag diagnosis and programming your vehicles? Here, obddiagnosticcenter.com will share with you new V2014.01 Multi-Diag user operation guide and help you activate it.

Step by step install and use obddiagnosticcenter.com multi-diag I-2014
1. Before installation to ensure not having connection networks or wifi active
2. Open folder (1) Key on the CD and run the file KeyUpdate. Then confirm and wait for the message successfully installed XXXXXX and OK
3. Start the installation folder (2) 1-2014
- If during your installation software request an unlock key 31-xxxxxxxxxx contact us with the key not give you the activation key valid
- Select the language it will continue the installation to completion after the message asking do you restart known not to install the following update etc once the last install
- Once the message you want to ask not restart known
4. Go to the following folder C: \ ACTIA \ portal and then delete the file WEGT.EXE
5. Once delete this file, open folder (1) Key on the CD and run the file KeyUpdate. Then confirm and wait for the message successfully installed XXXXXX and OK
6. Then install: xs-ime-pt-207p-workshop.exe. You can then restart the pc

Note: Do not connect Internet, WIFI and close Antivirus software

When you need helps or have any advice about Multi-diag Access J2534 OBD2 car diagnostic tool, you can direct visit our online service website www.obddiagnosticcenter.com or contact obd2motor@hotmail.com .