How to update Carprog and solve locked problem
by Magic Lee obd2repair CARPROG V4.01 is obd2 repair tool with all Software's activated and all 21 items Adapters. Some customers may have tried update the carprog full, then problem comes--the carprog is locked.CARPROG V4.01 CARPROG Full 4.1 CARPROG FULL v4.01
There is a tool you need get to update Carprog and solve locked problem, that is JLINK / J-LINK V8 Simulator ARM
JLINK V8 Simulator ARM USB JTAG J-Link ARM V8.00
Description: JLINK / J-LINK V8 Simulator ARM USB JTAG is full version and support firmware updates. J-Link emulation is SEGGER company ARM core chip to support the launch of the JTAG emulator. J-LINK V8 supports ARM7, ARM9, ARM11, Cortex-M3 core, ADS, IAR, KEIL development environment --
When you encounter this problem, how to do? you can fix it by youself
BEFORE ANY REPROGRAMMING DESOLDER FROM BOARD AT88SC
(8 PIN CRYPTO EEPROM AND DONT TRY TO READ OR WRITE!!!)
if this memory is already damaged solution will not work!
1.Use H-JTAG(JLINK J-LINK V8 Simulator ARM) for programming AT91 with dump.
H-Jtag schematic you will find in folder with H-Jtag software under Help pdf file!
also you can buy it on ebay for few usd
First of all you have to erase ARM.
Like shown on picture, if 1sec procedure doesnt work,
leave it connected 2-3 minutes.
after that connect h-jtag programmer(JLINK J-LINK V8 Simulator ARM) and programm processor with bin file
2.After successfull programming solder back at88 eeprom and run device
lib file must be in same folder as carprog.exe
carprog interface will work ok with all softwares up to v4.01
Sponsor Ads
Created on Dec 31st 1969 18:00. Viewed 0 times.
Comments
No comment, be the first to comment.