How to Save Your iPad From Water Damage?

It's always a little more difficult to drop an iPad into your toilet, bathroom, or sink than it is to drop an iPhone. However, there is a good probability that will happen. If you put your iPad into a tub of water by mistake, you should know that all hope is not gone. Electronics and water do not mix well, as everyone knows. And, wherever possible, it's best to avoid using gadgets while swimming, showering, or even having a private pool party. Even if you use quality iPad covers, it might not be enough to protect your device from impending water damage, especially it was underwater for too long. Then, you should contact a professional performing iPad water damage repair in Chullora to know the useful tips to recover your device. Scroll down and take a look at the tips to save your iPad from water damage.

Skip the rice

You may have heard that putting your wet iPad in a bag of rice can help you fix it. You might even be tempted to give this a try. But, to be honest, this is just a misconception. This will only allow the rice to fit through those small pores, causing severe harm to the iPad's electronic components. Not to mention that it exposes your device to dust, which can damage the motherboard and other sensitive components.

Avoid using a hair-dryer

Another thing to avoid when trying to dry your soaked iPad is this. Using a hairdryer could possibly spread the existing water inside your device to different parts of the device, causing it to become even more impeded.

Take out the case

The first step is to remove the wet back case from your iPad. This will allow most of the moisture from the headphone jack, charging port, and other water-damaged components of your device to evaporate.

Remove the SIM card

When performing iPad repairs in Chullora, make sure to remove the SIM card after most of the moisture has just been drained out. You cannot remove the battery from the device, however, you can save your SIM card.

Never switch it on when wet

Do not turn on your iPad if it is wet. Allow 24-36 hours for the water to evaporate. Keep it hanging for at least 24 hours before switching it the next day.

Shake the water out

This is dependent on the amount of water the item has been exposed to. You can give it a proper shake or use paper towels to soak as much moisture as possible.

Don’t put it near a space heater

Also, keep your wet device away from a space heater. Heat exposure could cause your device to blow, causing serious injury.

Hope, you have understood how to save your iPad from water damage. If you like the content of this article, don’t forget to share it with your friends, and give thumbs up!

Sponsor Ads

• Ad Space Available - Rent it Now!

Report this Page

Created on Feb 7th 2022 07:05. Viewed 179 times.

Share on APSense

Comments