How to Fix Linksys Router will not Reset to Factory Defaults?

by James B. software

As we all know that all the router fixing workarounds says the best resort is to reset it; however, the issue can still persist after that. In the following article, we have provided unique methods to fix the issues of the router. If you are also facing issues in your router, then read the below-provided workaround to attain a resolve instantly. Make sure that you read the article carefully to avail of the best results. So, let’s get started.

Run a 30/30/30 Reset

In case the user wishes to run a 30/30/30 reset, then they can pursue the mentioned instructions.

During the router is attached and turned on, long-press the Reset key for 30 seconds.
Detach the router from its source of power during even pressing down the key for 30 seconds again.
You should turn the power on again.
Then proceed to press the Reset for another second.
You have to leave the Reset key and let the router for a minimum of 10 seconds.
Now, detach the power cable for another 10 seconds, and connect again.

Execute an Optional Resetting Process

In case the user wants to execute an optional resetting process, then abide by the provided steps.

Go to the modem and disconnect it.
You should link the Linksys router to the system and port 1 at the router.
Navigate to the PC, to set IP Address to apply particular IP.
Set the ‘ 192.168.1.101’ (gateway requires to be set to 192.168.1.1).
Reach the router and hold the Reset key for some seconds.
The Ethernet light should turn off and then turn on again.
You should detach the router.
Then attach it back and instantly long-press the Reset key.
- The power indicator light begins blinking and keeps holding it unless it prevents doing so.
Now, the settings can be converted to factory standards.
Go to the browser and open it on the system.
Thereafter, you should enter the router standard IP 192.168.1.1.
The management display should show without any sign in or password required.
Go to the Setup option.
Then choose the ‘Mac Address Clone’ then turn it on.
You should hold the Clone tab.
Navigate to the Save settings option.
Navigate to the Administration to create a new password.
- This will boost you out, so sign in back using the username and password to ensure everything is right.
Later, you have to shut the browser.
Go to the system, adjust the IP back to Automatic, and fix the connection.
Finally, look at the status to ensure that you have an IP Address into the 192.168.1.xxx network.

Once you perform all the instructions thoroughly, launch the web browser for an instant Internet test. In case you can’t link, detach both the router and the modem. You have to wait for 30 seconds and then attach the modem first. Don’t forget the modem prepares to go already connecting the router back in also. After operating the router, fix the PC connection once again. You can be capable of accessing the Internet connection.

Conclusion

The primary motive of this article is to facilitate the users with the information of Fixing Linksys Router will not Reset to Factory Defaults. In the end, we hope that you will find this article useful and will accomplish your purpose through it.

Ava Williams is a McAfee product expert and has been working in the technology industry since 2002. As a technical expert, Ava has written technical blogs, manuals, white papers, and reviews for many websites such as mcafee.com/activate.

Source : Fix Linksys Router