Hot Runner Nozzle China

Anole hot runner nozzle is divided into 3 types: pin point gate, direct gate and vavle gate.

Anole hot runner pin point gate is applicable for most plastic material,advantages and characteristics:

1.Anole hot runner nozzle can be tooled as the cavity shape

2.bush easily changed

3.good color change capability

4.Prevent plastic drop and drawing

5.easy tooling for hot runner nozzle hole

 6.attention to the water channel near the gate.

7.pin point gate with small mark,perfect plastics apperance

8.select high thermal conductivity material to make sure heating fast,precision temperature control.

Anole direct gate hot runner is a nozzle with large flow and good color change capability.It can process front end of the the a single point direct gate hot runner to meet the requirements of cavity and gate.It is applicable for crystalline and low flow plastic parts,with good interchangeability .

1. direct gate hot runner is suitable for the gate on the incline side of plastic products

2.direct gate hot runner is applicable for low-flow plastic

2.direct gate hot runner can change color directly

4.direct gate hot runner bush and nozzle are structured separately,easy to exchange.

5.direct gate hot runner mould need not heat treatment, while bush heat treated with longer service life.6.single large gate standardized bush,easy to exchange.

7.direct gate hot runner bush is close to nozzle heating coil, which is good for thermal conductivity

We still work on research the best hot runner nozzele .Anole have the advanced design principle and strict quality control.Anole can offer the best injection solution.If you have any question of plastic mold hot runner, please kindly inform us.

Sponsor Ads

• Ad Space Available - Rent it Now!

Report this Page

Created on Dec 31st 1969 18:00. Viewed 0 times.

Share on APSense

Comments