Cummins Generator And Ricardo Generator Difference?

by Starlight Generator dieselgeneratortech

This article will help you understand the difference between Cummins generator and Ricardo generator from five aspects. If you are interested, take a few time to read it.

A represents Cummins generator, B represents Ricardo generator.

1. Performance Characteristics

A: Cummins patent technology PT fuel system, ultra-high injection pressure, to ensure good atomization of the engine and sufficient combustion.

B: The whole forged steel crankshaft, high quality alloy cast iron cylinder head, small size, light weight, small vibration, low noise, low oil consumption, and high reliability.

2. Cylinder Block

A: High strength alloy cast iron manufacturing, good rigidity, small vibration, low noise

B: Using the world’s leading technology, alloy cast iron material is uniformly, fine casting, high strength, light weight, compared with the same displacement diesel engine, the weight and volume are decreased significantly.

3. Cylinder Head

A: Four valves per cylinder, designed to optimize air/fuel mixture ratio, effectively improve the combustion and emission; such design is convenient for maintenance.

B: All cylinder heads are four valves, full air intake, smooth exhaust, and excellent performance; oil, water and air pipeline are inside the cylinder, which is economic and high efficiency; with alloy casting, the strength and stiffness are higher; replaceable valve seat and valve guide pipe effectively extend the service life of the cylinder head.

4. Crankshaft

A: Integral crankshaft is manufactured by high strength forged steel, the induction hardening process of the fillet and axle journal can ensure the fatigue strength of the crankshaft is higher.

B: The crankshaft is manufactured by high strength alloy steel full balance integral twist forging; the fillet and axle journal induction hardening improved the balance accuracy and shaft fatigue strength, the reliability is higher, and the service life is longer; the key process fully adopts the world’s advanced equipment processing.

5. Lubrication System

A: All moving parts are forced lubrication; large capacity gear pump provides pressure lubricating oil to lubricate the bearings and cool the pistons; oil cooler, full flow filters, and bypass filter can maintain the oil in a good condition.

B: Gear linkage lubrication pump is installed on lubrication system inside, which can alternate rotary lubricating oil filers and water-cooled multi disk oil cooling (blow by gas recycling).

Maybe You Are Interested in Ricardo Generator.