Artificial construction waste crusherby Richard Mrax Crusher Machine After we have known the working mechanism of the sand making machine, we can focus on the optimization of the workflow. The engineers of SBM Mining Machinery believe that the following five aspects should be noted. First, check if the observation door of the eddy chamber is closed to prevented the material from bursting out of the eddy chamber. Second, check the rotating direction of the impeller from the direction of the feed inlet. The impeller should rotate counterclockwise, otherwise you should adjust the wiring of the motor. Third, the startup sequence of the sand making machine and conveying equipment should be as followings: discharging sand making machine feeding. The crusher must be started without load. Feed after the construction waste crusher is in normal operation. The stop sequence is contrary to the boot sequence. Forth, the feed particles strictly follow the regulations. The materials which is greater than the specification should be forbidden into the crusher, otherwise, it would cause imbalance of the impeller or too much wear and tear of the impeller. The impeller channel and the central feed tube even may be blocked, which will make the crusher not work properly. Immediately remove the large feeding material when you find it. Fifth, if the discharge device stops moving, it is timely to stop feeding. Otherwise, the impeller will be crushed and the motor will be burned up. In order to ensure the normal operation of the construction waste crusher and give full play to the capacity of the equipment, the majority of sand making machine users should ideologically emphasis on the correct operation of the sand making machine with regular maintenance and periodic maintenance. Properly using the construction waste crusher is an important factor to ensure the continuous normal work of the sand making equipment. Improper operation or negligence in the operation will often cause the accident of the equipment and personal accident. Therefore, correct operation should be strictly in accordance with the provisions of the operating procedures.
Created on Nov 2nd 2017 05:33. Viewed 163 times.
No comment, be the first to comment.