315mhz/433mhz remote control code grabber scanner user manual

by Nancy N. DIY diagnostic and car repair tools 315mhz/433mhz Car key remote control Wireless Remote Key/Code Scanner Detect, receive, copy car remote control signals, then command the car as freely as the car'sowner, 315mhz/433mhz Remote Control Code Copier receives the signal sent by the fixed codeanti-theft system, save and copy the master's remote control signal Effective distance



315mhz/433mhz remote control code grabber scanner user manual

Function 1: (Scan/copy and save) receiption

1. Turn on the power. (the screen Display: Remote control Decode the tool)

2. Press any key on the remote control receiver. (Display the remote controlpassword)

3. By the host of the fifth key to save the password, you can save thirtyyards, more than thirty; it will automatically flush the code stored in thebeginning.

4. When press the sixth key, there is “*”, that means the device refuse acceptthe signal. And press the sixth key again, “*” disappear, and the device canaccept the signal again.

Function 2: Use as a remote control interfere-- transmit power

1. Press The first key and the second key together, display Remote co01001Decode the too S

2. Then Press the car Remote Control Code Detector key (the fifth key) to callthe saved password. What is the sequence you want to send out decided by thetimes of you press the fifth button (select the password by press the fifthbuton times, if you want select the first password ,you need press 1 time fifthbutton,and if you want select second password ,you need press 2 tmes fifthbutton,etc..)

3. And then press any key(first~fourth) to launches the password you selected.

If you want to change the launch password, you can set up it though the firstfour keys. After finished, you can press the fifth key to launch.

Function 3: Remote control code Detecting---Detector function

1. Press the fifth key of the Remote Control Code Detector one time, then thesecond key of theRemote Control Code coppier one time, finally the fifth key ofthe host one time. After doing that, it will start to scan. When scanning thepassword, it will open.

2 The fifth key of the Remote Control Code Detector is pause key. After thepause, you can freely to mobilize vibration resistance and address code.

3. The code condition it plays it as the following: two state code 0, 1. Threestates code 0,1,2. Three states code 0,1,2,3. 0, 1, 2, 3 representative for highlevel L, low level H and empty feet F.

Sponsor Ads

• Ad Space Available - Rent it Now!

Created on Nov 18th 2017 08:26. Viewed 468 times.

Comments