Elm 327 Wifi with Wireless for IPhone description and setup guide

Do you know WIFI327 OBD2 scanner ? Elm 327 Wifi is the latest PC-based scan tool.It supports all OBD-II protocols and is dispatched with a number of compatible programs. The output protocol (connection to laptop) is USB cable.It is easy to use and very useful to diagnose cars. It use WIFI327 software. 

A hardware device which allows you to wirelessly connect your vehicle's onboard computer from your any device with wireless and suitable software. Pc, mac, iPhone or iPod touch are supported. It is compatible with 1996 and later vehicles and installs in seconds.

Search wifi -- Connect to device (SSID: OBDDevice/CLKDevices)

Static Tab -- IP Address: 192.168.0.123 -- Subnet Mask: 255.255.255.0

Open Software (your iOS sofware (ex: Rev DashCommand, FuzzyCar )) 

Settings: Interface type : ELM -- Data Port : tcp://192.168.0.10:35000

There are tons of software available, which are fully compatible with WIFI OBD interface, such as engine running parameters monitoring, DTC reading and clearing, MPG meter, etc. 

By using the device you can monitor all these parameters from your PC, Mac, iPhone, Ipad etc with a compatible software or you can even write your own software on a specified hardware platform if need, because the AT commands are fully documented and very well explained. With proper software installed in the host device, you may have following parameters read out from your vehicle

RPM

Fuel Consumption

Engine Coolant Temp

Fuel Pressure

Calculated Engine Load

Throttle Position

Intake Manifold Pressure

Air Intake Temp

Timing Advance

Mass Air Flow

Fuel Level

Barometric Pressure

EVAP System Vapor Pressure

Fuel Trim

Some examples for iOS applications are Rev, FUZZYcar, DashCommand 

Note : Your vehicle may not support all above parameters. How many parameters you can get is depended on the vehicle manufacturer's implementation.

SAE J1850 PWM (41.6 kbaud)

SAE J1850 VPW (10.4 kbaud)

ISO 9141-2 (5 baud init, 10.4 kbaud)

ISO 14230-4 KWP (5 baud init, 10.4 kbaud)

ISO 14230-4 KWP (fast init, 10.4 kbaud)

ISO 15765-4 CAN (11 bit ID, 500 kbaud)

ISO 15765-4 CAN (29 bit ID, 500 kbaud)

ISO 15765-4 CAN (11 bit ID, 250 kbaud)

ISO 15765-4 CAN (29 bit ID, 250 kbaud)

SSID: OBDDevice / CLKDevices

IP/Port: 192.168.0.10:35000

Antenna: Internal

Power Consumption: 0.75 Watts

Wifi Standard: 802.11a/b/g

Operating Temperature: -15 to 100 Celsius

Item size: 15x13x4cm

Item weight: 5.50oz

1 x ELM327 WiFi Wireless OBD2 Interface

1 x Software CD

After that,you will know about the Elm 327 Wifi very much,and if you have the one ,you can research it to use for your vehicles.With more details, you can have a look at: http://www.vtoolshop.com

Report this Page