Products & Services
Truck Adblueobd2 Emulator for Scania Adblueobd2 Emulator Box High Quality www.x431update.org
Jan 7 2016 00:34
Product DescriptionTruck Adblueobd2 Emulator for Scania Adblueobd2 Adblueobd2 Emulator Box designed to disable Adblueobd2 system used in trucks, buses and other heavy vehicles with EURO 4/5 exhaust emission rates Adblueobd2 Emulator Box bypasses electronic module of the Adblueobd2 system on vehicle. Its very easy to fit Adblueobd2 Emulator Box to any truck or bus equipped with Adblueobd2 system and it will override Adblueobd2 system instantly, it will stop the usage of Adblueobd2 liquid. Adblueobd2 Emulator Box disables Adblueobd2 system electronics gently so there will be no power loss of the engine or any warnings on the dashboard and in diagnostic system. This device works without interfering to work of other electronic systems of the vehicle. Adblueobd2 Emulator Box has a wide range of supported vehicle models and there is only one version of emulator for all supported trucks, just upload the necessary program to the Adblueobd2 Emulator Box and you can install it on any supported truck. The connections details diagram and wire colours refer to Scania R500 Year 2008, but the main procedure of the minusblue module does not vary. Before proceeding make sure no faulty codes are memorised in the original ECU, Adblueobd2 liquid is higher than the reserve level and the truck batteries are disconnected from the system. 5 Conductors: 1) RED(+15). To be connected to a 24V source enabled when the engine key is in the ON position. This connection will supply power to the minusble Module when the engine key is on(dashboard on). SCANIA Adblueobd2 Emulator Activation The minusblue module and the original Adblueobd2 module CANNOT both be activated at the same time, the GREY ACTIVATION WIRE(+30) is to enable the minusblue module working. It is important to connect the GREY ACTIVATION WIRE(+30) to a 24V source always available(battery), moreover, the soldering operation must be done between the 20A fuse(F42) and the existing Adblueobd2 module. If you want to stop and exclude the original Adblueobd2 module from working, all that needs to be done is to remove the F42 fuse before starting the engine. The minusblue module will automatically be activated. To re-instate the original Adblueobd2 module, all that needs to be done is to reinstall F42 fuse before starting the engine. The minusblue module will automatically be de-activated. The minusblue module aquires the inputs from the CANBUS the first time the dashboard is turned on(key on but engine still off). 1) Make sure the F42 fuse is inserted. After this procedure the minusblue module will be activated whenever the dashboard is turned on(key on). The Result Will Be: 1) If the F42 fuse is installed the original Adblueobd2 system will be working. Both red and green leds will be on. LED FUNCTION ON - OFF
Skype : kellie-obding Whatsapp : + 86 133 029 50980 (16 Hours Online!) Company Website : www.x431update.org
Personal Website: www.x431update.com |